Trimble 4700/4800/5700 Receiver Kinematic Surveys

This is an outline of the steps needed to run a kinematic survey with the Trimble 4700, 4800, and 5700 receivers. It is only intended as a guide - refer to the manual for more details and options.

1. Start base station static survey using quickstart, programmed survey, or with the controller.
2. Insert memory card in slot in the TSC1 controller.
3. Connect the TSC1 controller to roving GPS receiver Port 1.
4. Turn on controller.
5. Select "Files/Job Management" on controller display main menu.
6. Create "New" or select an existing job. To create a new job, enter a job name and set file location to "PC card", select "No projection/no datum" as the coordinate system, and set reference elevation to 0.0.
7. "Esc" to main menu. Verify active job at the top of the screen.
8. Select "Configuration/Survey Styles" on controller display main menu.
9. Highlight "Trimble PP Kinematic" and press F2 (Copy) to create and name a custom survey style. Choose "Main memory" for file location. Press F1 (OK).
10. Select the custom survey style just created and press F5 (Edit) to edit the style settings.
11. Select "Rover options" and configure the options. Typical settings are:
    Survey type: PP kinematic
    Logging device: Controller
    Auto file names: Yes
    Logging interval: 1.0, 5.0, or 15.0s
    Elevation mask: 13 degrees
    PDOP mask: 6.0
    Antenna height: depends on application
    Antenna type: depends on application
    Antenna meas. to: depends on application
    Press enter to return to previous menu.
12. Select "Topo point" and configure the options. Typical settings are:
    Auto point step size: 1
    Quality control: QC1
    Auto store point: Yes
    Occupation time: 5s
    Number of measurements: 3
    Press enter to return to previous menu.
13. "Esc" to main menu.
14. Select "Survey" on controller display main menu.
15. Select the appropriate survey style, usually the custom style created for the specific job.
16. Select "Measure points". The survey is in roving mode until a point name is entered and the "Measure" button is pressed.
17. When the antenna is stationary over a point to be measured, enter a point name, antenna height, and measurement method, and press F1 (Measure). It is critical to that the antenna does not move while in static mode - from the time you press "Measure" until you receive the "Point stored" confirmation. The survey is back in roving mode after the "Point stored" confirmation.
18. Continue to measure points as appropriate throughout survey.
19. Do not end the survey until the survey has initiallized, indicated by "PPK=Fixed" on the survey status screen.
20. Press "Esc", then "End survey" to end the survey.

Last modified Thursday, 17-Nov-2005 03:57:00 UTC

Home | About Us | Contact Us | Support | Search | Facility | PBO | Education & Outreach

Comments: webmasterunavco.org
© 2008 UNAVCO, Inc.